Beadboard Master Bath: part 3 (recessed wall niches)

Part1: Beadboard
Part 2: Crown Molding Shelf


If part 1 was a 1 (in difficulty), then part 3 is definitely a 3, because I built recessed wall cubbbies/niches for storing towels and baskets of bath supplies (and it was tough, but fun).



1. Check for pipes/wiring
I was certain there were no pipes in this wall, but there was electrical cabling (these usually run along a stud), so I made my cuts with a space next to the studs (You can always cut more later, but not vice versa).

2. Cut into the drywall
OK. Moment of truth.  My husband, who hates putting nails in the wall, was having conniptions in the next room while I used my drywall saw to cut square rectangles into the wall between the studs.  I made my cubbies 12" tall and as wide as the studs allowed (usually 15").  The first "hole" was far from perfect, but "It doesn't have to be perfect to be beautiful". (I'm the Nester's biggest fan, you know.)  My other cubbies got better and better - yeah practice!  No worries either way; I knew I was going to have to frame them out later.

3. Make wooden boxes
I used 1/4" poplar boards ripped to the depth of the wall niche (~3¾), and cut just a little shorter than the height and width of the hole.  I should've used 1/2" general purpose molding boards, because the 1/4" poplar was too thin to nail together.  I used wood glue instead and it's holding up fine (knock on wood).  I also left the backs open (you could use luan or thin plywood to back).

4. Install boxes
If you measured right, they should come out even with the wall surface, sitting on the cut edge of the drywall.  If not, hold on to 'em so they don't fall into the wall (ha ha, one of  mine almost did).  Then I used finishing nails to nailed them in place. (Should I have used screws? Sturdier, yes, but also harder to hide.  The jury is still out on that one.)  For the box next to the wires, I nailed a 1/2" piece of wood "spacer" next to the wiring, and put my nail through that into stud (so there'd be no gap).

5. Frame it out
I used plain 1/4" poplar again (love that stuff) and cut it to the width of the space between the cubbies.  There were some painstaking careful adjustments to get this just right, but I'd say err on the side of too wide if you must.  Just nail these to the studs.  See how they're even with the top of the cubbies - I also tried really hard to make sure it was all level, because I took a thin piece of chair rail and ran that along the top.


6. Caulk and paint
Lots of caulk (along the back, between the box and shelf, and between the cubby and the frame) and then paint (3 coats).  Then I sat back to enjoy.  Worth the work?  Ummm... heck yes, I love pretty baskets (even if there's TP in them).

Remember the before!?


 Huge improvement!! I think I can finally say This wall is Done.

I'm linking this post up with













DIY Day @ ASPTL



Visit
Bookmark and Share
1931 Responses
«Oldest   ‹Older   2201 – 1931 of 1931   Newer›   Newest»
«Oldest ‹Older   2201 – 1931 of 1931   Newer› Newest»

Related Posts with Thumbnails